Quad crossroads wither skeleton farm
6.2payoffPayoff: how much farm you get for the effort. Production weighed against build difficulty and materials.Design by Elyrio3 · Tutorial by Elyro3 · Hand-picked and checked by a human
Watch the full tutorial on YouTubeAbout this build
A wither skeleton skull farm on a nether fortress with four crossroads side by side, built entirely in the nether. Three spawning platforms sit over the crossroads, and the bedrock roof above is removed so mobs spawn faster. Wither skeletons fall through drop chutes, dispensers put carved pumpkins on them to take them out of the mob cap, and a 20 bps mob conveyor carries them to the kill chamber. The player attacks every 14 game ticks with an auto clicker, and the hit detection runs the conveyors.
It suits a technical player with a quad crossroads fortress; the description links a tool that finds one on a seed. The video only shows the finished farm: build it from the world download or the schematic. The creator never tested it without a perimeter, and he says his testing was short and the farm has issues.
From the comments
- Build every spawning layer inside the crossroads' bounding box, layers outside it spawn no wither skeletons. The creator checked the box with MiniHUD.
- Set the auto clicker to 700 ms, which is 14 game ticks. Slower works, faster does not. The creator repeats it in four replies.
- If your hits trigger nothing, check the string in front of the hit detection observer. The creator's answer to a builder.
- In the world download the bottom dispenser of the left pumpkin elevator stays idle. Break the block in front of its observer clock or rebuild the clock. Two builders report it.
- Fill the dispensers and the hopper behind them with carved pumpkins as in the world download. The creator gives no count.
- Place fence gates where the wither skulls sit on the honey blocks, run the farm a minute, then swap in the skulls. The creator's tip.
Materials
No item list anywhere in the video or the description, and it is a showcase rather than a tutorial. Build it from the schematic above, the counts are in there.


